26
Error Code
Fault
Description
Solutions
E01
Failure communication
between controller and
computer
1. Check if computer is connected to controller with correct wires,
check connector, check if wire is damaged, or unplug and re-
connect
2. Change inverter and test
3. Change computer and test
E02
Motor connection
problem
1. Check if motor wire is connected well.
2. Check if controller is working, If not, please change one.
E03
Speed Sensor Failure
1.
Check if the speed sensor is properly installed and in place.
2.
Check if the speed sensor or the motor fan blades have dusts stuck in
them, if so clean it.
3.
Check to see if the speed sensor is working, change to a new speed sensor
4.
If new speed sensor doesn’t work, change controller
E04
Incline Calibration
1.
Will display on screen when under incline calibration.
2.
If incline isn’t calibrated and can’t use it will also display, please start the
incline calibration again.
3.
If still fails, change controller.
E05
Overload protection
1.
Protection is activated when current is overloaded, or when
motor cannot run properly. If it’s the second situation, examine
the treadmill and re-start it.
2.
Check if there’s un-normal smell. If so, please change motor or
Controller.
3. Check if electric voltage works in proper range.
E06
Rush protection
1.
Wait a few minutes and restart to see if it works normally. If there is a
burning smell, change controller
2.
Check motor wires are properly connected or damaged.
3.
Check to see the outlet powering the treadmill has enough voltage.
4.
If changing controller doesn’t help, change motor.
—
—
Computer doesn’t
detect safety key signal
1.
Check if safety key switch works, connecting wire works, or
magnet inside works.
2.
Safety key is not placed correctly
3.
Safety key is damaged
No display on
computer
No power
1.
Check if power cable is connected to machine or change to
another power outlet. If power switch is in position, test it by
switch ON/OFF. If the power switch is burned out, replace one
and make sure there’s power to machine
2. Check cable connection between computer and controller
3. Replace adaptor or computer
ERROR CODE &
SIGNIFICANCE
ERROR CODE &
SIGNIFICANCE
