Bodyworx J1650EA, Руководство пользователя, Страница: 19 / 27

RUNNING BELT TENSIONING ADJUSTMENT
If when you plant your foot on the belt, you can feel a slipping sensation then the belt has
stretched and is slipping across the rollers. All belts will stretch over time. This is a normal and
common adjustment on any treadmill. To eliminate this slipping, tension both Allen bolts on
the rear roller 1/4 turn as shown. Try the treadmill again to check for slipping. Repeat if
necessary, but never turn the roller bolts more than 1/4 turn at a time.
DRIVE BELT TENSIONING ADJUSTMENT
If you have tensioned the running belt and are still experiencing a slipping sensation, call your
dealer. Only an authorized dealer should perform tensioning of the drive belt.
LUBRICATING THE DECK
A well-lubricated deck will ensure high performance of your treadmill and reduce the level of
normal war and tear to important components. This treadmill has been pre-lubed at the factory.
However, for optimal performance, the running deck may require periodic lubrication. With
average usage (30 minute workout session at 5-6km/h 3 times a week for two people)
lubricate every four to six months. Your may adjust the timing of the lubrication based on the
intensity of the treadmill use level.
To check the lubrication level, simply lift the running belt, and put your hand as far into the
center of the belt as you can reach. If your hand shows signs of silicone, then it does not need
additional lubrication. If the board feels dray and there is very little evidence of silicone on
your hand, then additional lubrication should be added.
TO LUBRICATE THE DECK:
1. Stop running belt so that the seam is located on top and in the center of the deck.
2. Insert nozzle into spray head of lubricant can.
3. Lift running belt.
4. Position nozzle between the belt and the board approximately 200mm (8” ) from the front
of the treadmill.
5. Apply the silicon from the front to the rear of the treadmill on each side of the treadmill.
Try to reach the spray as far into the center of the running deck as possible. The spray
time should be approximately four seconds for each side.
6. Spread the silicon by running the treadmill at 1 Km/H and step gently on the belt from left
to right. Do that for a few minutes and allow the silicon to soak into the belt.
Owner’s Manual 19