en
PACKAGE CONTENTS
• Chest Belt
• Cinch-Mount™ or Flat-Mount™ End Fittings
Optional mounting hardware available
from Bodypoint
• Cam Buckles (Art. No. FS034-2)
• FrameSaver Clamps (Art. No. HW303-B-2)
Flat-
Ø 3/16”–1/4”
(5mm–6mm)
Cinch-Mount™
Flat-Mount™
/
X
Ø3/16"-1/4"
(5MM-6MM) Screw
Not Included
View from underside
Ø3/16"-1/4" (5MM-6MM) Bolt
Not Included
Diagram 1
#2 Phillips
Diagram 3
Diagram 2
Diagram 4
Framesaver Clamp
Cinch-Mount End Fitting
Flat-Mount End Fitting
POSITIONING
Seat user in wheelchair and establish correct
posture with pelvic support belt. Determine
desired position for the Chest Belt. To reduce
the risk of strangulation and trunk instability,
the belt should be neither too high nor too
low. When choosing position, consider inter-
ference with other devices.
INSTALLATION
Solid back wheelchair
1. Insert straps into end fittings. Wrap straps around
backrest. Mark holes for reference.
2. Attach end fittings to backrest. Mounting screws
must have a minimum pullout strength of 200lbs/
90kg. Not included in package.
ADJUSTMENT
Position user in wheelchair and fasten the
pelvic support belt securely. With Chest Belt
properly adjusted and the strap tightened, it
should fit snug so the user’s trunk is secure.
Small adjustments in fit are done by using the
adjustment strap. Large adjustment in fit are
accomplished at the end fittings.
SAFETY CHECK
When properly positioned in wheelchair, have
user lean forward and side to side to check fit.
Check for:
1. Normal operation of adjustment strap.
2. Comfort – If any rubbing occurs
relocate belt.
3. Position – If too high or too low,
adjust mounting location.
4. Interference with other devices – Relocate
belt as necessary to clear armrests,
accessory pads, or feeding tubes.
