- 9 -
7.
MAINTENANCE
1. If the belt tends to move off the center, stop the treadmill.
Take the Hex Wrench 6mm and adjust the Hex Screw in the
Rear End Cap. For example, if the running belt is moving
towards the left side, tighten the left Hex Screw about 1/4
turn(clockwise); if the running belt is moving towards the
right side, tighten the right Hex Screw about 1/4
turn(clockwise); Turn on the treadmill after it has been
adjusted. If you find that the belt has not moved to the proper
position, please repeat the steps above. Don’t use the treadmill
until the running belt returns to the center position.
(Ps.1. This action is very important, if the belt is not in the
center, be sure to follow above steps.)
(Ps.2. The position of running belt might not stay precisely in
the center with slightly towards the left and right sides,
and the situation varies with how end-users use and the
weight of end-users. No need to adjust the belt if it doesn’t
rub against the parts aside.)
2. Depending on the usage of the product, please apply
SILICON on the board according to the below chart. Use
the Hex Wrench 6mm to unscrew the bolt inside the Rear
Roller. Then pull the belt up and daub some SILICON to
the center of the board. After that, adjust the belt to the
center of the deck, followed by tightening the screw to the
original set.
(Ps. When the belt is sliding, please follow the above method
to lubricate the running belt. )
Speed(KGS)
Interval
1~6 km
1 year
6~12 km
6 months
12~16 km
3 months
