Bodyguard T360, Руководство пользователя

Страница: 24 / 36

Possible Chest Strap Heart Rate Problems
All Bodyguard ® machines are compatible with the Polar wireless heart rate system. This includes a chest strap and a
receiver. The receiver is an integral part of the machine and it is hidden inside. The chest strap is an option on all machines
and can be purchased from Bodyguard
® Polar. If you are having some problems with the reception, please use the following
troubleshooting check list.
Troubleshooting Check List – Table 1
The above table should help properly diagnose the problem. There is also misconceptions that the signal is immediate.
The chest strap electrodes need to be moistened in order to send a strong signal. Radio and neon light interferences can also
reduce the strength of the signal.
Possible Contact Heart Rate Problems
I n order to properly diagnose any problem with the conctact heart rate system, please refer to the following procedures.
This machine uses a hand ECG (Electrocardiogram) printed circuit board along with wires and a set of metal plates. The hand
ECG board is an integral part of the machine and is hidden inside.
Troubleshooting Check List – Table 2
24
PROBLEM
• No signal.
• Weak signal.
• Erratic signal.
POSSIBLE CAUSE
• Dead battery in strap.
• Electrodes are not wet.
• Using wrong strap.
• Weak battery.
• Electrodes are not wet enough.
• Strap is not tight enough.
• Too much body fat.
• Chest size too small or too big.
• Receiver has a problem.
• Using wrong strap.
• Interference with other signals.
• Electrodes are not wet enough.
SOLUTION
• Change battery.
• Put water on electrodes.
• Use Polar.
• Change battery.
• Put water on electrodes.
• Put on tighter.
• No solution.
• Position strap accordingly.
• Verify signal in Diagnostics,
see Heart Rate Test section.
• Use Polar.
• Move the machine away from
potential interference sources.
• Put water on electrodes.
PROBLEM
• No reading
• Erratic reading
POSSIBLE CAUSE
• Hands have not been in contact
with the metal plates long enough
• Defective hand contact board
• Wires are not connected properly
• Hands may move too much on the plates
• Defective board hand contact board
• Strong neon lights too close to console
• Interference with other signals
SOLUTION
• Wait for 15-20 seconds before
a reading
• Change ECG board
• Verify Wiring
• Do not move your hands
• Change board
• Move the climber
• Use only this machine to verify