BODYFLEX BF40HA1, Инструкция по эксплуатации

Страница: 15 / 34

E
E
X
X
E
E
R
R
C
C
I
I
S
S
E
E
C
C
O
O
M
M
P
P
U
U
T
T
E
E
R
R
FUNCTION BUTTON
MODE: Choose each functions by pressing mode key, in scan mode, press mode key can lock the current
function. Press mode key and hold 2 seconds to reset all functions figures.
FUNCTIONS
SCAN: The sequence of display:
TMR→SPD→ DST→CAL→PULSE. In scan mode, press mode key to choose
other function. Automatically scan through each mode in sequence every 6 seconds.
SPEED: Display current training speed, the maximum is 999.9KM/H.
TIME: Accumulates workout time from 0:00 to 99:00.
DIST: Accumulates total distance from 0.0 up to 999.9KM.
CAL: Accumulates calories consumption during training from 0.0 CAL to the maximum 999.9 CAL.
(This data is a rough guide for comparison of different exercise sessions which can not be used in medical
treatment.)
PULSE: With pulse signal into for 5 seconds, the current pulse will display.
WARNING! Heart rate monitoring systems may be inaccurate. Over exercise may result in serious injury
or death. If you feel faint stop exercising immediately”.
NOTE
1. With no signal transmitted into the computer for 4 minutes, the computer will shut off the LCD display
automatically, and all function values will be reserved.
2. Monitor battery spec: 1.5V UM-3 OR AA (2PCS)
3. If the computer display abnormally, please re-install the batter and try again.
4. When the display of LCD is weak, it mean the batteries need to be changed.
5. WARNING! Heart rate monitoring systems may be inaccurate. Over exercise may result in serious injury or
death. If you feel faint stop exercising im
mediately”.
TROUBLE SHOOTING:
1. Change the battery. To change the computer battery, please slide the computer from the computer holder,
remove the battery cover on the back of the computer console, and remove the batteries. Replace with AA
batteries. Finally put the cover back on the console, and slide the computer back on the computer holder.
2. Computer not working correctly. If your computer is not working correctly, please check whether the lower
sensor wire is connected to the upper sensor wire, and make sure the upper sensor wire is plugged into the
computer. When you have checked the above, and the computer still not working, then please make sure the
batteries are installed correctly in the computer and that the batteries are still working.
3. No resistance. If there is no tension resistance on the bike, please make sure the upper tension cable is
connected to the lower tension cable.
MAINTENANCE
1. Before using the bike, always make sure all bolts/nuts are fully tightened.
2. A spent battery is hazardous waste, please dispose of it correctly, and do not throw it in the trash.
3. When eventually you want to scrap the machine, you should remove the batteries from the computer, and
dispose separately as hazardous waste.