1. Attach the Leg Press Main Frame (202) to the Weight Base Connector (207),
using two 3/8" X 4" Hex Bolts (229), three 3/8" Washers (238) and one 3/8" Nylon
Nuts (241). One nut welded on Weight Base Connector End (207) to Leg Press.
Attach the Long Leg Press Connector (205) to the Leg Press Main Frame (202),
using two 3/8" X 4" Hex Bolts (229), four 3/8" Washers (238) and two 3/8" Nylon
Nuts (241).
2. Attach the Base Stabilizer (201) to the Leg Press Main Frame (202) using two
1/2" X 3-1/4" Hex Bolts (227), four 1/2" Washers (237) and two 1/2" Nylon Nuts
(240). Attach a 45 X 75mm Rect. Cap (214) to the bottom rear of the Leg Press
Main Frame (202). Attach a 50 mm Sq. Caps (215) to each end of the Base
Stabilizer (201).
3. Slide a Bearing Housing (212) onto each end of the welded axle on the Rear Leg
Press Support (208) and then bolt the Bearing Housings (212) to the Leg Press
Main Frame (202) using four 1/2" X 1-3/4" Hex Bolts (228), eight 1/2" Washers
(237) and two 1/2" Nuts (240).
4. Attach the Front Leg Press Support (206) to the Leg Press Main Frame (202)
using one 5/8" X 6-1/2" Hex Bolt (226), two 5/8" Washers (236) and one 5/8"
Nylon Nut (239).
5. Attach the Foot Plate Connector (209) to the Rear Leg Press Support (208) and
the Front Leg Press Support (206) using one 5/8" X 6-1/2" Hex Bolt (226), two
5/8" Washers (236) and one 5/8" Nylon Nut in each Leg Press Support.
6. Attach the Foot Plate (210) to the Foot Plate Connector (209) using two 1/2"
Washers (237) and two 1/2" Nylon Nuts (240). Attach two 45 X 75mm Rect. Plugs
(216) to the Foot Plate (210).
7. Attach the Right and Left Leg Press Handles (203 & 204) to the Leg Press Main
Frame (202), angle facing up, using two 3/8" X 3-1/8" Hex Bolts (230), four 3/8"
Washers (238) and two 3/8" Nylon Nuts (241).
8. Attach the Seat Pad for Leg Press (225) to the Leg Press Main Frame (202) using
two 3/8" X 1" Hex Bolts (234), one 3/8" X 2-3/4" Hex Bolt (231) and three 3/8"
Washers (238). Attach the Back Pad for Leg Press (224) to the Back Pad
Adjuster (211) using two 3/8" Washers (238) and two 3/8" X 1" Hex Bolts (234).
Screw the Locking Spring Knob (220) into the Leg Press Main Frame (202) and
the slide the Back Pad Adjuster (211) into the Main Frame (202). Adjust to the
desired position by pulling the Locking Spring Knob (220).
Tighten all bolts gradually, from ground - up.
STEP 2
-5-
