C5
C6
C7
C3
C1
C4
C2
CONNECTING CABLE (51A)
STEP 5 Connecting Cable
ball end
bolt end
C1
51A
25
C2
108
3
130
61
51A
51
C6
61
7
108
122
77
122
77
130
110
1
111 122
130
C3,C5
C3
C5
C7
107
18
130
C4
T5
24
110
130
61
51
51A
10
1. Screw the threaded end of the Connecting Cable (51A) into the Single Pulley Block (25) approximately half
way as shown inset C1.
2. Route the terminal end of the Connecting Cable (51A) over the top of the inside (right side) pulley mounted
on the Top Frame (3) as shown inset C2.
3. Continue the cable routing down and around pulley C3 mounted on top of the Base Frame (1) as shown
inset C3, using one 3/8" X 1-3/4" Hex Bolt (110) and one 3/8" Nut (130). The Connecting Cable (51A) enters
this pulley on the weight stack side and exits on the outside.
Note:
The pulley bracket welded to the base
frame directly behind the weight stack is not utilized unless you have purchased the optional Leg Press
Attachment. See the Leg Press assembly manual for routing of the leg press cable.
4. Mount a pulley in the second-from-bottom hole in the Floating Pulley Block (24) using one 3/8" X 1-3/4" Hex
Bolt (110) and one 3/8" Nut (130). Then continue the cable up and over this pulley as shown in inset C4.
5. Continue the cable routing down and under a pulley you will now mount in the slot in the Base Frame (1),
using one 3/8" X 2" Hex Bolt (111) and two 3/8" Washers (122). Enter the rear of the pulley and then slide
the cable through the Base Frame (1), exiting through the hole in the End Cap (64).
6. Run the cable through the slot in the front of the Seat Support (7) and attach the cable to Leg Extension
Cable Arm (18) as shown in inset C7, using one 3/8" X 3" Hex Bolt (107) and one 3/8" Nut (130).
7. Slide a pulley into the slot in the front of the Seat Support (7) and secure using one 3/8" X 2-3/4" Hex Bolt
(108), two 3/8" Plastic Pulley
Spacers (77), two 3/8" Washers
(122) and one 3/8" Nut (130) as
shown in inset C6.
