Product Assembly
S
TEP 1a: Leg Weight Holder
Attach the ADJUST TUBE (2) onto the LEG WEIGHT HOLDER - Assembly (1-ASM) using:
●
One HEX BOLT, 1/2" x 3-1/4" (12)
●
Two FLAT WASHERS, 1/2" (11)
●
One NYLON NUT, THICK, 1/2" (14).
Once fully tightened with movement in parts, see
TIP
below, then install both NUT CAPS (7).
TIP:
Fully tighten HEX BOLT (12)
then loosen the locking NYLON
NUT, THICK (14) approximately 1/4
turn so that the LEG WEIGHT
HOLDER - Assembly (1-ASM) &
ADJUST TUBE (2) pivot freely with
little to no excessive movement
1. Attach LEG WEIGHT HOLDER(112) onto
ADJUST TUBE(111), using HEX HEAD
BOLT(151), two 1/2" WASHER(153) and NYLON
NUT(152).
2. Insert FOAM ROLLER HOLDER(113) into the
ADJUST TUBE(111) and LEG WEIGHT
HOLDER(112).
3. Slide FOAM ROLLER(131) onto each side of
FOAM ROLLER HOLDER(131).
4. Attach END PLUGS(123) to FOAM ROLLER
HOLDER(113) and attach 50 SQ. END
PLUG(122) to ends of LEG WEIGHT HOLDER(112).
5. Slide RUBBER BUMPER(125) onto WEIGHT
HOLDER(112). The SPRING CLIP(142)
is used to hold weight plates on WEIGHT
HOLDER(122).
6. L PIN(143) is used to lock LEG WEIGHT
HOLDER(112).
S
TEP 1b: Foam Roller Holders
Insert all three FOAM ROLLER HOLDERS (3)
into the ADJUST TUBE (2) and the LEG
WEIGHT HOLDER - Assembly (1-ASM).
Place all parts from the box in a cleared area and position them on the floor in front of you. Remove
all packing materials from your area and place them back into the box. Do not dispose of the
packing materials until assembly is completed.
Read each step carefully before beginning.
3/4 SOCKET &
6” EXTENSION
3/4 WRENCHES
Recommended Tools
9/16 SOCKET &
6” EXTENSION
9/16 WRENCHES
Recommended Tools
2
