12
S T E P
1
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. DO NOT wrench tighten unless instructed.
Some components may be pre-assembled. Nylon lock nuts will not fully screw onto
bolts, they must be wrench tighten to fully go on.
1A.
Attach Rear Stabilizer
(C)
to Base Frame
(A)
using:
2 - (#1) M12x105mm Hex Head Bolt
4 - (#8) M12 Flat Washer
2 - (#14) M12 Nylon Lock Nut
1B.
Attach Ankle Lock Frame
(H)
to Seat Frame
(D)
using:
4 - (#6) M8x20mm
2 - (#9) M8 Flat Washer
2 - (#15) M8 Nylon Lock Nut
1C.
Attach Two End Caps
(#24)
to Back Rest Adjustment Frame
(B)
as shown using:
2 - (#24) End Caps
2 - (#13) M6 Lock Washer
