Body Solid Powerline PPR-200X, Руководство пользователя, Страница: 14 / 18

PPR-200X
STEP 3
BE CAREFUL TO ASSEMBLE ALL COMPONENTS
IN THE SEQUENCE THAT THEY ARE PRESENTED.
NOTE:
finger tighten all hardware in this step. DO NOT wrench tighten
until the last step. some components may be pre-assembled.
nylon lock nuts will not fully screw onto bolts, must wrench tighten.
3A. attach pull up bar (C) to both pull up frames (F) using:
4 - (#4) M12X75mm hex head bolt
4 - (#6) M12 washer
4 - (#5) M12 nylon lock nut
3B. attach rear frame (G) to both pull up frames (F) using:
2 - (#3) M12X65mm hex head bolt
4 - (#6) M12 washer
2 - (#5) M12 nylon lock nut
3C. attach rear frame (G) to the rear of rack frames (A)
using:
4 - (#2) M12X70mm hex head bolt
4 - (#6) M12 washer
4 - (#5) M12 nylon lock nut
3D. insert a small post (E), one on each side, into one of the
openings on the rear of rack frames (A) and secure
using a pin (#7).
3E. insert a large post (D), one on each side, into one of the
openings on the front and rear of rack frames (A) and
secure using a pin (#7).
3F. insert end caps into each end opening of rear frame (G)
using:
2 - (#9) 50X50mm end cap
14