5
No.1 Main Frame
No.22 Spindle Bar
No.9 Right Lower Handleber
No.21 D Shape Washer
No.35 Washer
No.20 Spring Washer
No.19 Hinge Screws
No.25 Crank Set
No.11 Right Pedal Post
No.14 Undee Washer
No.15R Pedal Handlebar
No.17R Nut
No.18 Spring Washer
Fig.2
S
S
T
T
E
E
P
P
2
2
Insert the Spindle Bar (pt.22) through the Right Lower Handlebar (Pt.9)and through the main frame, and then,
through the Left Handlebar (Pt.10). Put a D shape washer and a Spring Washer (Pts.20 &21) on either side of
the spindle bar and tighten up both ends using the Hinge Screws (Pt.19)
Then insert a Pedal Hinge Bolt (Pt.15R) and a Undee Washer (Pt.14) through the Pedal Post (Pt.11 for the right
side, Pt.12 for the left), put a Spring Washer (Pt.18) on the bolt, then pass it through the Crank (Pt.25), and secure
the bolt with an M12 Nut (Pt.17R). Repeat this procedure for the left side.
ATTENTION:
The Right and Left Bolt (15R&15L) must fully penetrate the nylon ring inside the
connecting Tube (11&12) and the Right and Left Crank (25). This will ensure the
stability and durability of you AERO ELLIPTICAL STRIDER.
In order to install each hinge bolt properly, keep it straight as the Hinge Bolt
goes through the connecting Tube and the Crank. If the Hinge Bolt is connected
to the Crank at an angle, damage to both the Hinge Bolt and the Crank may
occur.
CAUTION: MAKE SURE ALL THE BOLTS AND NUTS ARE SCREWED
TIGHT PRIOR TO WORKOUT.
NOTE: Right pedal hinge bolt should be turned
clockwise. The left pedal hinge bolt should be
turned anti-clockwise.
