Body Champ PBC528, Руководство пользователя

Страница: 11 / 16

PBC528 PBC530 PBC602 Page 10
Assembly STEP 3
With the help of an assistant, attach the
Pull-Up Bar (#05)
to the
two
Upright Frames (Upper) (#23)
. Secure them together using
Using the drawing for reference, insert and rotate as necessary the
Left/Right Safety Catches (#06/07)
and
Left/Right Weight Rests
(#08/09)
so they are securely resting and fully engaged through
Hardware Required
#17 Hex Bolt (M10x80 mm)
[4 Pieces]
#20. Nylon Nut (M10)
[4 Pieces]
four Hex Bolts (#17) , four Big Washers (#19) and four Nylon
Nuts (#20) - all as shown in the illustration.
At this point, secure ALL the
Nylon Nuts (#20)
that were hand
tightened in previous steps with appropriate tools.
your desired hole settings in the Upright Frames (lower) (#03)
and the Left Upright Frame (Upper) (#23) . Always make sure
both Safety Catches (#06/07) are installed at the same hole height
settings, and both Weight Rests (#08/09) are also installed at the
same hole height settings to prevent serious injury and/ or improper
usage. #19 Big Washer (M10)
[4 Pieces]
THE ASSEMBLY PROCESS IS NOW COMPLETE.
However, for your own safety, please make sure to read this entire Owner’s Manual which includes
safety instructions and warnings, as well as any safety/warning labels affixed to the product before use.
For your safety , please visually and functionally inspect and test the unit after assembly is complete.
NOTE:
FLOOR ANCHORS
This piece of equipment includes four (built-in) Floor
Anchors (#21) that allow the user to mount the equip-
ment to the floor.
Floor mounting is optional but highly recommended
as it increases stability in pieces of equipment that are
used often or used with heavy weight. Mounting
hardware is NOT PROVIDED, but can easily be
obtained at your local hardware store.
Find a qualified store employee to help youselect the
proper type of hardware for your type of installation,
whether it be into concrete, a wooden subfloor, etc.