BR
M
6
1
10
Page
16
Assembly Instructions
Seat Assembly
Remove the Washer and Nuts that are pre-assembled on the back
of the
Seat (#70
) and set them aside as they will be used in a later
process. Attach the
Seat (#70)
onto the
Horizontal Seat Bar (69),
ensuring that it is pointing directly toward the short end of i t and then
tighten with three
Washers (#37)
and three
Nylon Nuts (#38)
that
were previously removed. Attach the
Horizontal Seat Bar (#69)
onto the
Seat Post (#65)
by inserting the bolt (on the bottom of the
Horizontal Seat Bar(#69
)) through the
Seat Post (#65)
and use a
distance of the seat from the
sure to tighten the
Insert the
Seat Post (#65)
into the
mouth of the post that is protruding
Main Frame (#1)
.
Make
sure
the holes on the
Seat Post (#65)
are facing the front before
insert.
Screw in the
Spring
Loaded Knob (#63)
through the
Main
Frame (#1)
post and
holes located on the
Seat Post
(#65)
. The
Spring Loaded Knob (#63)
has a safety feature that allows
you to loosen it by turning it counter clockwise three times as you pull it
outward. Adjust the seat height and then pop the knob back in. Tighten
the knob by turning clockwise. See the illustration below.
Knob (#66)
to secure it. This knob can be loosened to adjust the
handle bars. Make
from the
then through any one of the
knob after making any adjustment.
A s s e m b l y S t e p
10
Hardware Required
AC Adapter Assembly
Plug in the
AC Adapter (#17)
male plug
into the female socket located at the rear
end of the unit.
61
#66. Knob (M10)
#63. Spring Loaded Knob
3
3
1
1
Spring Loaded Knob Operation
Turn knob counter-clockwise three times.
Pull knob outward and adjust seat simultane-
ously
Push knob back inward until it clicks and then
tighten it by turning clockwise.
W A R N I N G
Do not remove the
Seat (#70)
for any
reason after you have installed it.
Exercising on this unit without the
Seat
(#70)
can result in SERIOUS INJURY.
Ensure the seat is locked in place by
tightening the two knobs prior to use.
