CUSTOMER SERVICE 1-888-707-1880 MAURICE PINCOFFS CANADA ©2009
6
STEP 2. ATTACHING THE REAR STABILIZER AND THE BACKREST SUPPORT
BRACKET
Attach the rear stabilizer
(5)
with two end caps
(18)
to the rear bracket of rear frame
(2)
.
Secure using 2 carriage bolts
(19)
, 2 curve washers
(64)
, 2 spring washers
(25)
and 2
cap nuts
(6)
.
NOTE
: If the cycle is not on even ground, you can use the end caps
(18)
to adjust
the level your cycle.
Insert the seat post sleeve
(54)
into the main tube of the front frame
(1)
.
Connect the upper sensor wire (72) to the lower sensor wire (73)
Insert the backrest support bracket
(4)
into the mounting tube of the main frame
(1)
.
Secure in your desired position using the quick release knob
(50)
.
NOTE
: Ensure that the wire is safely tucked inside the opening so that the wire does
not get pinched when inserting the backrest support bracket into the frame.
HOW TO USE QUICK RELEASE KNOB
A) TIGHTEN THE QUICK RELEASE
(1) Insert the quick release knob
(50)
through the hole of seat post mounting tube
(1)
and the
backrest support bracket
(4)
.
(2) Tighten the quick release knob
(50)
in a clockwise direction.
Please note quick release is with +/- mark on surface.
B) LOOSEN THE QUICK RELEASE
(1) Loosen the quick release knob
(50)
in a counterclockwise direction.
(2) Pull the quick release knob
(50)
and slide the backrest support bracket
(4)
into your desired
position.
(3) Insert the quick release knob back and tighten in a clockwise direction.
NOTE
: Ensure that you fasten the bolts securely to avoid shaking and discomfort when
cycling.
6
25
64
6
25
64
19
2
1
54
4
50
18
5
18
73
72
