Bodmer Ton AG
Holzrüti 1
CH-8840 Einsiedeln
Phone
+41 55 418 28 58
Website
www.bodmer-ton.ch
2
1.
Introduction
The controller SE-96 enables you to exactly control your furnace. Three of the nine available
programmes are already pre-set for the most common uses. You can always alter and save any of
these programmes to fit your individual needs. The controller is fixed to the side of the furnace by a
mount that is delivered along whit the controller. You can easily take the controller out of the mount
to set up a programme and put it back after the programme has been started.
Important note:
-
Do not put the controller on the top of the furnace during the firing process.
-
Do not alter the length of the cable connecting the controller to the furnace in any way).
All of our controllers are checked and tested intensively in our company. But if there is a
malfunction, please try to find out the problem using chapter 5 of this manual. If the problem
cannot be solved this way, please contact us.
2.
The first start
The controller is connected to the furnace by the controller’s cable with a connector. This connector
fits only in one position, and therefore cannot be hooked up wrong. At the bottom of the controller is
the main power switch. When you switch on the controller, the current furnace temperature will be
displayed. The controller is now ready to be programmed.
