READ AND FOLLOW ALL SAFETY INSTRUCTIONS
! IMPORTANT SAFEGUARDS !
WHEN USING ELECTRICAL EQUIPMENT, BASIC
SAFETY PRECAUTIONS SHOULD ALWAYS BE
FOLLOWED, INCLUDING THE FOLLOWING:
SAVE THESE INSTRUCTIONS
THIS PRODUCT CONTAINS A RECHARGEABLE NICKEL-CADMIUM BATTERY.
THE BATTERY MUST BE RECYCLED OR DISPOSED OF PROPERLY.
© Philips Emergency Lighting
A Division of Philips Electronics North America Corporation
236 Mt. Pleasant Rd. • Collierville, TN USA 38017-2752 • Tech Support 888-263-4638 • Fax 901-854-1630 • www.philips.com/bodine
70094006
Installation Instructions
1. To prevent high voltage from being present on red & yellow output leads prior to installation, inverter
connector must be open. Do not join inverter connector until installation is complete and AC power is
supplied to the emergency ballast.
2. This product is for use with one 13 W - 42 W or two 13 W - 39 W (4-pin) compact fluorescent lamps without
integral starters.
3. The emergency ballast must be connected to an unswitched AC power source (120 or 277 VAC, 60 Hz).
4. When installing the emergency ballast, make sure all connections are in accordance with the National
Electrical Code and any local regulations.
5. To reduce the risk of electric shock, disconnect both normal and emergency power supplies and inverter
connector of emergency ballast before servicing.
6. This product is for use with indoor fixtures except air handling heated air outlets, and wet, damp, or
hazardous locations.
7. Do not attempt to service the battery. The emergency ballast uses a sealed, no–maintenance battery.
Contact the manufacturer for information on service.
8. The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
9. Do not install near gas or electric heaters.
10. Servicing should be performed by qualified service personnel.
11. Do not use this equipment for other than intended use.
CF94
Ni - Cd
EMERGENCY LIGHTING EQUIPMENT
04/06/11
