5. Affix rubber feet onto roll holder plate. See step # 8 photo to orientate feet.
6.
You will need to relocate the back two feet. As shown in the photo below.
7. Install the floor plate onto the bottom of the Lemur-X UPG printer. Align the two holes on the floor plate up with
the two mounting holes on the printer. Install the two 3/16
” hex head Taptite screws and tighten.
8. Flip both the Lemur -X and attached floor plate so all rubber feet are facing down.
9. Align the two holes on the roll holder up with the two mounting holes on the floor plate. Install the two 3/16
” hex
head Taptite screws and tighten.
14.75
” length
Do not cover mounting holes
10.50
” height
