BOC Edwards EO2K, Инструкция по эксплуатации

Страница: 23 / 62

EO2K, EO4K and EO6K Diffusion Pumps
IN
STALLATION
PAGE
17
Issue G 17 Aug 06
3 INSTALLATION
3.1 Safety
• A suitably trained and supervised technician must install the pump.
• Disconnect and isolate the other components of the vacuum system from the electrical supply so
that they cannot be operated accidentally.
• Where necessary, get someone to help you move the pump (refer to Section 3.3).
• Ensure that the products handled by the pumping system are compatible with the materials of
construction of the pump (see Section 2.8). If you have any doubts about the compatibility, contact
your supplier or BOC Edwards for advice.
• Do not use solvents to clean ‘O’ rings.
• Ensure that the installation technician is familiar with the safety precautions which relate to the
pump fluid and to the products handled by the pumping system.
• Wear the appropriate safety clothing when you come into contact with pump fluid or contaminated
components. Dismantle and clean contaminated components inside a fume cupboard.
• Vent and purge the vacuum system with nitrogen for 15 minutes before you start installation work.
3.2 Unpack and inspect
1. Remove all packing materials and protective covers and check the pump. If the pump is damaged,
notify your supplier and the carrier in writing within three days; state the Item Number of the pump
together with your order number and your supplier's invoice number. Retain all packing materials
for inspection. Do not use the pump if it is damaged.
2. Check that you have received an EO pump and a fitting-pack, and check that the fitting-pack
contains the items listed in the appropriate Table 10, Table 11, or Table 12 (see page 18). If any of
these items is missing, notify your supplier in writing within three days.
3. Check that your electrical supply voltage corresponds to the voltage stated on the pump
identification and rating plate. If the pump is not suitable for use with your electrical supply, do not
continue to install and use the pump.
If the pump is not to be used immediately, refit the protective covers. Store the pump in suitable
conditions, as described in Section 6.1.
WARNING
Obey the safety instructions given below and take note of appropriate precautions. If you
do not, you can cause injury to people and damage to equipment.