BOC Edwards A730-01-983, Инструкция по эксплуатации, Страница: 37 / 44

Nov 02 Issue A
XDS Dry Pump
SERVICE, SPARES AND ACCESSORIES
PAGE
31
31
7 SERVICE, SPARES
AND ACCESSORIES
7.1 Introduction
BOC Edwards products, spares and accessories are
available from BOC Edwards companies in Belgium,
Brazil, Canada, France, Germany, Hong Kong, Italy,
Japan, Korea, Switzerland, UK, USA and a world-
wide network of distributors. The majority of these
centres employ Service Engineers who have
undergone comprehensive BOC Edwards training
courses. Order spare parts and accessories from
your nearest BOC Edwards company or distributor.
When you order, state for each part required:
• Model and item number of your equipment.
• Serial number (if any).
• Item number and description of part.
7.2 Service
BOC Edwards are supported by a worldwide
network of BOC Edwards Service Centres. Each
Service Centre offers a wide range of options
including: equipment decontamination; service
exchange; repair; rebuild and testing to factory
specifications. Equipment which has been serviced,
repaired or rebuilt is returned with a full warranty.
Your local Service Centre can also provide BOC
Edwards engineers to support on-site maintenance,
service or repair of your equipment.
For more information about service options,
contact your nearest Service Centre or other BOC
Edwards company.
7.3 Accessories
7.3.1 Electrical cables
Refer to Table 10. The following electrical cables are
available as accessories and should be used to
connect the XDS35i to your electrical supply:
7.3.2 Silencer
A silencer is available for the pump. The code
number for the silencer is A505-97-001. Refer to
Section 3.6 for guidance on its use. A silencer spares
kit, code number A505-97-801 is also available.
7.3.3 Gas ballast adaptor
Fit the gas-ballast adaptor in place of the gas-ballast
control on the pump. The adaptor allows you to
connect a controlled supply of inert gas to the pump.
Gas-ballast adaptor A505-02-000.
7.3.4 Solenoid operated pipeline valves
Fit the pipeline valve between your vacuum system
and the pump inlet to provide additional system
protection when the pump is switched off. The
following valves are available as accessories and are
recommended. (Refer to Table 11).
7.3.5 Tip seal service kit
This kit contains all the necessary components to
replace the tip seals. Tip seals should be replaced as
a pair, and only simple tools are required. The kit
part number is A730-01-805.
Product description Ordering information
Lead Assembly, 13 A, C19, UK A505-05-003
Lead Assembly, 16 A, C19, Europe A505-06-003
Lead Assembly, 15 A, C19, USA A505-07-003
Lead Assembly, 20 A, C19, No Plug A505-08-003
Table 10 - Electrical cables