BobsCNC E4, Инструкция по сборке

Страница: 5 / 102

Page 5
Required Tools
To assemble the kit together you will need the following:
•
Two ½ ” end wrenches to tighten Z Bearing nuts.
•
A pair of long nose pliers to hold the nuts.
•
Diagonal Cutters or sharp knife to trim nylon ties.
•
Calipers or measuring tape to measure part placement.
•
Small standard screwdriver to connect electronics.
•
Small Phillips screwdriver to mount home switches and stepper motors.
•
Medium Phillips screwdriver to build the main components.
•
Sand paper to remove laser marks on the faces.
•
M4 Star Driver for DeWalt disassembly.
•
LOCTITE® 243 thread lock (fingernail polish can be used as a substitute).
•
Wood Glue (e.g. Titebond®) for Spoilboard Assembly
To operate the E4 CNC Router you will need:
7/16” & 5/8” wrench to change router bits.
Computer with control software for GRBL.
Material for Project.
1/8” or 1/4” Router bits.
Dry lubrication (e.g., graphite, Teflon® or silicon spray).
Tools you may need for the electronic setup include:
Multimeter to correctly connect the power supply and stepper motors. A multimeter is a good tool to have for general
electronic trouble shooting.
Quick Start and Troubleshooting guides are available to help you get up and
running. Please check BobsCNC.com for the latest version.
Getting Started
•
We recommend using a large flat, clean working surface for assembling your E4.
•
All screws (unless noted) should be installed snug, then rotated one 1 to 2 1/2
turns.
•
Light sanding of the wood surfaces will clean up the marks made by the laser.
•
Painting or applying stain with a clear coat will give added protection to the wood
components.
•
During assembly try placing 1 inch strips of blue painters tape behind the T - Slots to
hold the nuts in place during assembly.
*For More Information: Click on the Links