Bob's Space Racers WATER BLAST LINKABLE, Руководство по эксплуатации

Страница: 16 / 39

BOB’S SPACE RACERS® WATER BLAST
TM
(LINKABLE) ARCADE
16
3-3. Detailed Troubleshooting and Repair:
3-3-1. Changing the Water:
1. Set the game's GAME / DRAIN valve to the drain position.
2. Press the PROGRAM button on the game's programming panel to
access the programming options.
3. Press the OPTION button and advance to the DRAIN option.
4. Press the VALUE button to turn the pump on and off.
NOTE: THE PUMP IS RUN ON A GROUND FAULT INTERRUPTER
CIRCUIT. THIS IS TO PROVIDE A HIGH DEGREE OF SAFETY TO
THE CUSTOMER. IF THE PUMP DOESN’T RUN WHEN THE GAME IS
STARTED, CHECK THE RESET BUTTON ON THE GROUND FAULT
OUTLET ON. THE RESET BUTTON MUST BE DEPRESSED DURING GAME PLAY TO BE ACTIVATED.
PUSHING THE RESET BUTTON WHEN THE GAME IS OVER WILL NOT HAVE ANY EFFECT.
5. Hold the drain hose into the 5 gallon pail and press the VALUE button to start the pump.
6. Run the pump until ALL of the water empties out of the tank. Turn off the pump
7. Turn the GAME / DRAIN valve to the GAME position when draining of the water is complete.
8. Remove the cash box assembly and slide the pump outside of the game to service and clean the filter assembly.
9. Remove the screen at the bottom of the tank and clean both the tank and the screen. Re-install the screen.
10. Add 5 gallons of water to a bucket and add 1 TBSP Cascade Dishwashing powder. (This will help keep the game
clean). DO NOT use too much Cascade or foaming will result. Fill tank to proper level as required.
SUGGESTION: ALTHOUGH ANY WATER CAN BE USED, USE DISTILLED WATER WHENEVER POSSIBLE.
DISTILLED WATER HAS ALL OF THE MINERALS REMOVED AND WILL DRASTICALLY EXTEND THE TIME
INTERVAL BETWEEN WATER CHANGES.
11. Clean the inside of the glass with a plastic scrub pad to remove dirt and sediment from the glass.
NOTE: IF THE GLASS IS BADLY STAINED, USE C.L.R. MINERAL REMOVAL SPRAY FIRST TO GET RID OF
TOUGH MINERAL DEPOSITS.
12. Spray RAIN-X on the inside of the glass to help prevent minerals from forming on the glass.
13. Press the PROGRAM button on the game's programming panel to access the programming options.
14. Press the OPTION button and advance to the DRAIN option.
15. Press the VALUE button to turn the pump on and off.
16. Hold the drain hose into the 5 gallon pail and press the VALUE button to start the pump.
17. Run the pump until the water comes out of both guns in a steady stream. Check game for any leaks and proper
water pressure.
18. Turn the GAME / DRAIN valve to the GAME position; put 5 gallons of fresh water in game.
WARNING: BEFORE SLIDING PUMP BACK INTO PLACE, PLAY THE GAME, CHECKING FOR WATER LEAKS,
AS THIS WILL CAUSE SEVER DAMAGE TO GAME.