Assembly instructions for
SWOOP CHAIR
Step 1:
Unpack carton and place all parts on a
non-abrasive floor.
Step 2:
Remove plastic cover from upholstered seat
cushion (B)
Step 3:
Attach the chair back frame (A) to the
Upholstered seat frame (B) by using flat washers,
spring washers and bolts (#3) through the pre-drilled
holes in the rear comer blocks of the wood seat
frame and into the chair back frame (A). Apply
gentle downward pressure on the seat until you can
insert all the bolts to the insert nuts to connect the
seat frame with the back frame. Use hand to tighten
bolts securely . (Don't use Allen Key (#1) yet).
Attach the chair back frame (A) to the
Upholstered seat frame(B) by using flat washer,
spring washer and short bolt (#2) through the
pre-drilled hole at the center of the back rail of the
seat frame. Do not tighten all screws & bolts until
the seat is fully assembly
Step 4:
Step3
-
_/,/
-----
Step4
B
Page 2 of 2
This step requires installation of six bolts
C
Attach front legs (C) to the comer blocks of the wood
seat frame (B) by using flat washers, spring washers
and bolts (#3) through the pre-drilled holes in the
front comer blocks of the wood seat frame. Then use
hand to tighten all bolts securely. (Don't use Allen
Key(#l) to tighten yet).
This step requires installation of four bolts
Most floors have slight irregularities that can
effect chair leveling. If your chair is uneven when
placed in its desired location , perform the following
step:
1. Loosen all the bolts for front legs and back frame.
2. Gently push downward on the back of the seat,
then push on the front edge of the seat until all four
legs rest on floor.
3. Once the chair is level, use Allen Key(l) to
tighten all bolts securely again.