Cub_DTG r10-09 Page 3 of 5
Warning
Risk of electric
shock
Disconnect power
supply before
removing cover
Information and Troubleshooting
for the B-705 Cub
TM
Dryer
For complete set of Installation Instructions refer to form No. 705-69
http://www.bobrick.com/Bobrick/Install_Instructions.aspx
Information about the Dryer:
•
Model B-705 Cub
TM
is not designed for vandal-prone installations. For vandal-prone
installations use Bobrick AirCraft
®
dryers with cast-iron, vitreous enamel finished covers.
•
There are no replacement parts available for this dryer except for the cover.
Product Type:
B-705 Series A
Electrical Characteristics:
Model B-705, 115V, 9A, 1035W, 60HZ, Single Phase, cULus listed.
Model B-705E, 220-240V, 6.5A, 1500W, Single Phase, VDE approved, CE marked.
Removal of Cover
Start installation of dryer by removing cover. Remove
two screws, from the bottom of the dryer. Pull bottom
of the cover away from the mounting base. Rotate
cover up until tabs on top of the cover release from
the top of the mounting base.
When the tabs on top of the cover are separated
from the top of the mounting base, the cover can be
removed.
If a fault occurs with the dryer:
1. Check that the electrical supply is OK.
2. Check that the circuit breaker is switched on.
3. Check that sensor is clean and not obstructed, the sensor optics can be cleaned with
a cotton swab.
Replacement Parts
705-150
Dryer Cover Series A
