In the U.S.A.: BOBRICK WASHROOM EQUIPMENT, INC.
#OMMERCE$RIVE#LIFTON0ARK.EW9ORKs4EL s&!8
(ART3TREET.ORTH(OLLYWOOD#ALIFORNIAs4EL s&!8
In Canada: BOBRICK WASHROOM EQUIPMENT COMPANY
2OLARK$RIVE3CARBOROUGH/NTARIO-2"s4EL/NTARIO%AST &!8
s4EL-ANITOBA7EST &!8
© 2011 by Bobrick Washroom Equipment, Inc.
Form
No.
2112-269
r1/5/11 Printed
in
U.S.A.
REPLACEMENT PARTS LIST
Part Name
Part No.
Valve Replacement Kit
4112-79
Collar Nut for Valve
4112-19
Window with O-Ring
2112-38
BobKey
24-17
VALVE REPLACEMENT INSTRUCTIONS
TO REMOVE VALVE:
1. Open filler-top by inserting BobKey (24-17) into slot of filler-top and then slide latch to the left. Lift up filler-top.
2. Loosen locking-screw inside dispenser. Remove dispenser from wall and empty soap container.
3. Place 1" (25mm) closed-end wrench (provided) inside soap container and over the large collar nut at rear of soap valve and loosen until
face of valve can rotate.
4. While holding the collar nut in place with the wrench, unscrew soap valve from the front of
the unit by rotating counterclockwise.
TO INSTALL VALVE:
A. On Units With Round Hole In Soap Container
1. Pull back flat rubber washer at rear of soap valve face to expose the two plastic tabs.
2. Cut plastic tabs off rear of soap valve face flush with indicated surface (see Figure 4).
3. Move flat rubber washer back to its initial position. Make sure flat edge of washer is even
with the top of valve face.
4. Hold the collar nut with the 1" (25mm) closed-end wrench. Make sure the notch in the collar nut is facing toward the front of the
dispenser and position nut behind soap valve hole inside dispenser.
5. Screw new soap valve into collar nut, clockwise, until rear of valve face hits the front of the soap container. Adjust so that spout faces
downward.
6. Tighten collar nut with wrench until tight enough so that valve will not leak around seal at front of unit.
7. Install soap dispenser on wall plate.
B. On Units With Notched Soap Valve Hole In Container
1. Hold the collar nut with the 1" (25mm) closed-end wrench. Make sure the notch in the collar nut is facing toward the front of the
dispenser and position nut behind soap valve hole inside dispenser.
2. Screw new soap valve into collar nut, clockwise, until rear of valve face hits the front of the soap container.
3. Push the soap valve into the soap container with valve tabs in the soap valve hole notches with spout facing downward.
4. Tighten collar nut with wrench until tight enough so that valve will not leak around seal at front of unit.
5. Install soap dispenser on wall plate.
INSTRUCTIONS FOR INSTALLATION AND MAINTENANCE
Bobrick ClassicSeries
®
Models B-2111 and B-2112 Surface-Mounted Soap Dispensers
FIGURE 4
Soap Container
Soap Valve
4112-79
Collar Nut
4112-19
Wall Plate
Screw
Window
with O-Ring
2112-38
BobKey
24-17
Plastic Tabs
to be Cut Off
Flush with this Surface
Plastic Tab (2)
Flat Rubber Washer
(moved back to
expose plastic tabs)
QA010511