Bobot WIN 701, Руководство пользователя, Страница: 10 / 21

The machine is slipping
The cloth is too wet or the track is
wet
A. Replace the sponge absorbent cloth
equipped with the machine.
B. Dry the water on the track with a dry cloth.
First, wipe the glass manually (up, down,
left and right) with the remote control,
and then make further operation
The machine is attached to the glass surface
The machine does not run
smoothly
The glass is too wet or the glass
surface is sticky
During the operation of the
machine,when it reach on the
top glass frame , will not
continue to operate
Red light flickers, buzzer rings
synchronously, voice prompt: please
put it again, baby can't stand stably.
During the operation of the
machine, flash the red light
During the operation of the
machine, there is squeaking
noise between the machine
and the glass
The machine finished the window
cleaning action and did not stop at
the initial position of the machine
When the machine stops at a certain
position during operation, the red light
flashes and the buzzer rings synchro-
nously,Voice prompt: Please rearrange,
baby stand unsteadily
The machine can not be started or the
machine does not act according to the
preset path rules, and the red light
flashes at the same time
The red light flashes and the buzzer
rings synchronously.
Voice prompt, please fasten the
safety rope.
Red light flashing, buzzer rings;
voice prompt: please connect the
power supply
The red light flickers, the buzzer
rings synchronously; the voice
prompt: if the machine fails, please
look the call center for help
Power failure
Other abnormal equipment Contact our after-sales personnel
Check whether the power supply is cut off
or the connection of machine power input
interface and extension line is poor
(fastening nut if it is not tightened)
The safety rope is not locked or
broken
Check whether the safety rope is
locked properly
Fall proof sensor abnormal
A. Check that the cloth are properly
installed
B. Check the glass if have some gaps
C. Check glass window frame for
uneven rubber
A. Check that the cloth are properly
installed
B. Fall proof sensor damaged
The friction force on the surface of
the polished glass is different
Lack of vacuum
Manually control the machine to a convenient
position by remote control
The glass surface is too dry or there
is too much dust on the anti drop
sensor
The machine edge sensor senses the
signal of moving out of the glass
frame
Ignore it
A. Spray water on glass surface or cloth
B. Remove the dust attached to the anti fall
sensor.
Wrong measurement of machine
edge impact current
The machine is not attached to the
glass
The machine is attached to the glass surface