Bob Carver 27813, Руководство по эксплуатации

Страница: 3 / 15

3
Quick Start Guide
1.
Locate the seven vacuum tube boxes, four large and
three small.
2.
Place the Crimson 275 according to the ventilation
suggestions on page 6 of this manual.
3.
Carefully insert the tubes into their sockets following
the diagram at right and the further details on page 00
of this manual.
4.
Connect the outputs of your preamplifier/DAC to the
RCA inputs of the Crimson 275. Make sure that the
gain/volume control on your preamplifier/DAC is
turned down. See page 8 for more hook-up instruc-
tions.
5.
Connect the output terminals of the Crimson 275 to
your loudspeakers. See page 8 for more details.
6.
Connect the IEC power cable between the Crimson 275
power socket and the wall receptacle.
7.
Power up your preamplifier/DAC.
8.
Flip the Crimson 275 rear panel POWER switch to
ON.
9.
Wait two minutes for the tubes to warm up.
10.
Activate your music source and slowly advance
the volume control on your preamplifier/DAC.
11.
Enjoy! If you don’t hear any sound, turn off your
preamp/DAC and Crimson 275, and re-check your
connections, or see the Troubleshooting Section
on page 00.
12A T 7
KT120 KT120 KT120 KT120
12A T 7 12A X 7
L
R
R L
OUTPUT OUTPUT
R INPUT L
–
RIGHT
+ –
LEFT
+
AC INPUT
+
–
+
–