BNR6400 Tech Manual.indd • 07242013
Page | 4
• Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and any
other condition that may affect the power tool’s opera-
tion. If damaged, have the power tool repaired before
use. Many accidents are caused by poorly maintained
power tools.
• Use the power tool, accessories and tool bits etc. in ac-
cordance with these Instructions, taking into account
the working conditions and the work to be performed.
Use of the power tool for operations different from
those intended could result in a hazardous situation.
SERVICE
Have your power tool serviced by a qualified repair person
using only Identical replacement parts. This will ensure that
the safety of the power tool is maintained.
PRECAUTION ON USING MIXERS
Attention! - You must abide by the following basic safety
measures to prevent electrical shocks, injuries and the dan-
ger of fire when using electric tools. Read and abide by these
instructions before you start to use any tools.
These Instructions must be kept in a safe place.
• The equipment must never be used in areas where an
explosive atmosphere exists.
• Never mix in solvents or substances containing solvent
that have flash points below 21°C.
• Do not let the cable touch any parts of your body,
• Only use the extension cord approved for use in the
working area.
• The unit must only be started and stopped when it is
inside a mixing vessel. Ensure that the mixing vessel is
placed on a solid, secure base,
• Never reach into the mixing vessel with your hands or
any other object during the mixing process.
• We recommend that you always wear industrial safety
gloves and safety goggles when working with the mix-
er.
• Wearing close-fitting clothes is mandatory.
• Always allow for reaction torque
• Always wear a dust mask
Before Initial Operation
Check to see that the rated voltage on the tool nameplate
corresponds to the tool requirement. Before using the tool,
read the instruction book carefully.
Mixer Assembly (Fig. 2):
First screw mixer shaft (6a) together with mixer paddle (6b).
Screw the mixer paddle (6) into the mixer (5). Use the two
wrenches to tighten. Use one of the wrenches (a) to hold
the mixer (5) in place and then use the second wrench (b)
to tighten up the mixer (6). Proceed in the reverse sequence
to undo the paddle from the mixer.
STARTING THE MIXER
Ensure that the data listed on the nameplate matches the
voltage before connecting the unit up to power.
On / Off switch
• Switching on: Press the switch (1)
• Continuous running: Press the locking knob on the
switch (1) (2) to lock it in place.
• Switching off: Press the switch (1) briefly
• Speed control: Use the speed control (3) to select the
speed.
• Switching between 1st· 2nd gear (4)
