3. MOUNTING INSTALLATION
The heater is supplied with a multi-functional mounting bracket and 4 x M8 ring hooks if you wish to hang the heater.
LOCATION
- For best results, do not mount higher than 2.4m (small models) and 2.8m (large Models). If you need to exceed this height either
mount on the multi-functional bracket so the heater is at an angle facing downwards or use the hanging hooks supplied. Direct air flow away from
occupants, posts, and columns, including equipment. Ideally allow the warm air to travel parallel to the outside walls, along the most exposed part of
the building, which is normally subjected to the prevailing winds (see pictures at bottom of page).
MULTI-FUNCTIONAL BRACKET
- Using the
pictures above and to the right decide on the best
mounting method to suit your requirements. Fix the
bracket to the wall or roof making sure you use
suitable bolts for the surface you are fixing the
bracket too and ensure it will take the weight of the
heater. Place the stud on the heater through the
bracket, add the washer and secure in place using
the nyloc nut supplied.
HANGING HOOKS
– Place the nut onto each hook
first then fully screw them into the heater, finally
tighten the nuts against the heater body to stop
them rotating.
1
3
4
5
6
2
7
8
9
If you use the heater in mounting position 7, 8 or 9 you
MUST remove the 2 side panels turn them around 180° and
reinstall them. Would you also please turn around the front
guard so our Logo reads correctly. Many Thanks
Single heater location
Multi heater locations
