BN Products HB-16W, Инструкция по эксплуатации

Страница: 5 / 12

HB-16W Handling Instructions
Page: 5
• Do not cut or bend materials harder than and or other than “Grade 60 or 420MPa” re -
bar. As they will either crack or fly out or cause machine failure.
• Do not force the power tool. Use the correct power tool for your application. The correct
power tool will do the job better and safer at the rate for which it was designed
• Do not use the power tool if the switch does not turn it on and off. Any power tool that
cannot be controlled with the switch is dangerous and must be repaired.
• Disconnect the plug from the power source and/or the battery pack from the power tool
before making any adjustments, changing accessories, or storing power tools. Such pre -
ventative safety measures reduce the risk of starting the power tool accidentally.
• Store idle power tools out of the reach of children and do not allow persons unfamiliar
with the power tools or these instructions to operate the power tool. Power tools are dan-
gerous in the hands of untrained users.
• Maintain power tools. Check for misalignment or binding or moving parts, breakage
of parts and any other condition that may affect the power tools operation. If damaged,
have the power tool repaired before use. Many accidents are caused by poorly maintained
power tools.
• Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cut -
ting edges are less likely to bind and are easier to control.
• Use the power tool, accessories and tool bits etc., in accordance with these instructions
and in the manner intended for the particular type of power tool, taking into account the
working conditions and the work to be performed. Use of the power tool for operations
different from those intended could result in a hazardous situation.
Service
• Have your power tool serviced by a qualified repair person using only identical replace -
ment parts. This will ensure that the safety of the power tool is maintained.
• Keep tool clean at all times for best and safest performance. Follow these instructions
for lubricating and changing parts. Keep hands dry and free of oil or grease. Inspect
switches, tool cords periodically and have them repaired or replaced by an authorized
service center if damaged. Check moving parts for alignment and binding as well as for
breakage and improper mounting. Damaged parts should be repaired or replaced by an
authorized service facility.