Page | 5
BNT-40-Wire-P
Diameter (in.)
ø 0.03 (21 Gauge)
Material
Q195 Polycoated
Length (in.)
3937 (approx)
Battery and Charger Usage
Before inserting or removing the battery from this tool, please set the main switch to the
off position.
•
To avoid a short circuit to the battery, always use the battery terminal cover when it
is not in use with the tool.
•
When placing the battery into the tool, press the battery lock before placing it into
the battery holder. When removing the battery, press the battery lock button before
pulling it out of the battery holder.
•
Use 100-240V ~ 50-69Hz AC power supply for the charger. Fully insert the battery
into the charger slot and it will begin to charge automatically as indicated by the
charging light. It will take approximately 74 minutes to fully complete the battery
charge.
•
It is recommended to charge the battery between 32°F and 113°F. Do not charge in
extreme cold or hot environments.
Machine Operation and Methods
•
Before inserting or removing the wire spool turn the main power switch to off and
lock the trigger.
•
When installing the wire spool in this tool only use recommended wire that is clean
and rust free.
•
Only use recommended wire spools. Using non-standard wire or spool could cause
the tool to malfunction.
•
Press and lock the lever.
•
Push the Reel Stopper to release the Reel Stay
(door) and open.
•
Cut about 2 inches of wire off the end of the coil.
•
Install the wire spool with the left side facing the
tool (left is marked on the spool). Close and latch
the Reel Stay (door).
•
Insert the wire into Wire Guide C. Note: the wire
must not be bent or curved.
•
The wire must pass through Wire Guide C and in
between the two feeding gears until it reaches the
flared tube. Then push the wire an additional ½ inch
into the flared tube.
•
Release the Release Stopper and confirm the
Release Lever has returned to its original position.
Note: the wire must be clamped in between the
feeding gears.
