PAGE | 4
ishing speed. Excessive pressure will
overload the motor causing possible
damage from overheating.
• Do not polish one spot too long.
• When used in one spot for extend
-
ed periods, 50 and 100 grit polishing
pads will remove excessive mate- rial,
making the surface uneven. Excessive
pressure may overheat the motor.
• If this occurs, turn off the polisher
and wait until the polishing disc or
blade come to a complete stop. Then
remove the polisher from the work
piece.
• Remove your hand from the vent
area, remove the polishing disc, then
(with your hand removed from the
vent area) turn on the polisher and
run it free, without a load, to cool the
motor.
PACKAGE CONTENTS
Your wet polisher is shipped with the
following contents
• Wet polisher with water supply line
and hose adapter
• Water shroud
• Ground Fault Circuit Interrupter
(GFCI)
• Shaft wrench (2)
• Side Handle
• Gearbox cover
• Operation manual
Located on the top of the gearbox is
a shaft lock pin. Press this pin to stop
the shaft from spinning when install-
ing a backer plate or securing arbor
nuts. Do not press shaft lock pin when pol-
isher is running. Doing so will damage the tool
and can cause injury.
GFCI
The polisher should only be used with a GFCI.
Before each use, test and reset the GFCI. If the
GFCI does not test and reset properly, replace
it before using the polisher. The GFCI may re-
set automatically each time the tool is removed
from the power outlet, in this case you will
need to depress the reset button prior to use.
WATER FLOW ADJUSTMENT
The water adjustment lever is located on the
under side of the polisher.
GEAR BOX COVER
The plastic gearbox cover is designed
to allow the polisher ’s gear box with
out feeling the heat created by the
tool. Before using tool, make sure
all han- dles are securely fastened.
WATER SHROUD
The water shroud is easily attached
and removed using the actuating le-
ver. Slide the shroud over the polisher
head with the lever in the open posi-
tion. Use the adjusting screw to open
the collar to the correct size. Close
the lever to tighten the shroud
onto the polisher head.
All manuals and user guides at all-guides.com
