BN Products BNG4000iE, Руководство пользователя

Страница: 13 / 37

13
1. Turn off the connected electrical equipment and stop engine.
2. Reduce the total power rate of connected electrical equipment
within the rated output range.
3. Check whether the cool air inlet is blocked by foreign matters and
whether the relevant control parts are abnormal. If there is any problem,
remove it immediately.
4. Restart the engine after checking.
Notice: When using the electrical equipment with high starting
current(like compressor and sinking pump...), the overload
indicating light may will flash for few seconds. But this doesn’t
belongs to troubles as aforementioned.
4.3 AC Indicating Light(GREEN)
The AC indicating light will be on while the
engine starts and keep normal output.
4.4 ECO Switch
①
“ON”
While the ECO
switch is on position of “ON”, the equipment will control
rotating speed according to the connected load, so as to get good fuel
oil consumption and low noise.
②
“OFF”
While the ECO
switch is on position of “OFF”, whether it connects with
load, the engine also runs at a rated rotating speed.
（
3600r/min
）