background image

X5 DVD Video System II Installation Guide  

 
This installation guide is intended to be used as a supplement to the BMW Installation Instructions for X5 DVD Video 

System II.  The kit comes with the audio/video cables but I chose the Streetwires Zero Noise-Series cables to prevent 
any interferences or noises from entering into the system.  The part numbers and prices for the Streetwires cables are 

listed below and they can be bought from Crutchfield, other online retailers, or your local audio shops.  Because I am 
very paranoid about noises and rattles inside the vehicle, I took one extra step to deaden any possible rattles by cutting 

the felt tape into small strips and wrap them around the A/V and power cables.  The felt adhesive tape can be bought at 
Michael’s, JoAnn Fabrics, or any hobbies/craft stores. 

 
It took me about 4 hours to complete the installation.  The hardest part was the installation of the overhead console.  The 

BMW Installation Instructions states the average installation time for the whole kit as 2.5 hours.  I took my time to make 
sure that it’s done right and not damage the interior or headliner.  If your headliner color is other than black, make sure 

you use a clean pair of painter’s gloves to protect the headliner from smudges.  Also make sure that you label all cables 
and connectors as they all look alike.   

 
The DVD Video System plays all DVD discs (including DVD+R, DVD-R, DVD+RW, DVD-RW, and DVD-ROM).  It also 

plays all video CDs. 
 

If you have any questions, I’ll be glad to answer them for you.  Contact me at 

[email protected]

 or post a message on 

Roadfly’s X5 forum (

http://bimmer.roadfly.org/bmw/forums/e53/

). 

 
 

PART NUMBERS 

 

DVD Overhead Console (Grey)   

84 11 0 153 363 

 

DVD Overhead Console (Beige)  

84 11 0 153 362 

 

DVD Overhead Console (Black)   

84 11 0 153 235 

 

DVD Overhead Console (Green)  

84 11 0 153 364 

 

DVD Installation Kit 

 

 

84 11 0 151 233 

 

RECOMMENDED TOOLS AND ADDITIONAL PARTS 

 

Torx-20, Torx-25 drivers 

 

8mm, 10mm sockets 

 

Phillips screwdriver 

 

Small, flat-tip screwdriver 

 

Painter’s gloves (1 pair) 

 

Felt Adhesive-Backing Paper 

 

1/8” drill bit 

 

Drill 

 

CD changer carrier bracket (if you don’t have a CD changer installed in trunk) 

 

StreetWires Zero Noise Mobile Video Cable

 (11.5 ft) – Crutchfield 211ZNV35 $34.99 

 

StreetWires Zero Noise 2 Stereo Patch Cables

 (11.5 ft) – Crutchfield 211ZN235 $19.99 

 

One blind plastic rivet (51 71 7 002 953) - $0.45 

 

Rivet Setter or Pliers 

 

  

Содержание X5 DVD Video System II













Отзывы: