EN/9
Retrofit / Installation kit No. 82 83 0 136 518
Installation Instructions No. 01 29 0 136 536
Issue date: 10.2001
4.
To install the amplifier and additional wiring harness (for cars with a battery in the boot)
0
0
0
0
0
Secure the bottom amplifier holder (5) to the
amplifier (1) with the two fillister head self-tapping
screws 3.5 x 9.5 (2).
Secure the adapter cable
A
along the main wiring
harness (40) with cable ties (18).
Align the amplifier (1) and ensure that you do not
jam or damage any of the cables. Then tighten the
securing screw (41) for the control module box and
the hexagonal nut with collar M8 (9).
If the car has an auxiliary heating system,
now reinstall the Telestart receiver you
removed earlier.
0
The figure shows the engine compartment on
the right near the control module box.
Secure the adapter for the earth connection (3) to
the earth post (40) near the brake booster using
the existing hexagonal nut M8.
0
Lay the earth cable (40), brown cable, with the 6
mm cable eyelet and the power cable (41), red
cable on the adapter cable
A
through the opening
(42) into the control module box in the engine
compartment on the left.
0
Carefully
cut open the rubber grommet (40) in the
front a little.Carefully push the earth cable (41),
brown cable with 6 mm cable eyelet, through the
opening you have made in the rubber grommet
(40).Then secure the 6 mm cable eyelet (42) to the
adapter for the earth connection (3) using the
hexagonal nut M6 (4).
Seal the rubber grommet (40) around the
opening you cut using sealing compound.
5
1
2
9
A
40
41
18
046 0630 B
3
40
046 0631 B
41
A
40
42
046 0632 B
42
40
3
41
4
046 0633 B
