BMW 740i SEDAN, Руководство пользователя

Страница: 77 / 211

76 n
Check Control
Priority 2
These alerts for problems are reported
for 20 seconds when the ignition key is
in position 2. The status reports remain
after the message disappears. You can
view the message again by pressing the
CHECK button.
> TRUNK LID OPEN
This message is given only when ini-
tially starting off.
> DOOR OPEN
This is displayed after a minimum
vehicle speed is exceeded.
> FASTEN SEAT BELTS
*
In addition, the indicator lamp with
the safety belt symbol appears and
an acoustic signal is heard.
> WASHER FLUID LOW
The washer fluid is too low. Top up
the fluid at the earliest opportunity.
Refer to page
142 .
> CHECK ENGINE OIL
Add engine oil as soon as possible.
Refer to page
143 .
> OUTSIDE TEMPERATURE 24 7
(–5.0 6 )
This display is only an example. The
current reading appears at an outside
temperature of 37.5
7 (+3 6 ) and
below. Refer also to page 72 .
> TIRE PRESSURE SET
*
The RDC has imported the current in-
flation pressure in the tires as the tar-
get values which the system will
monitor.
Refer to page
94 .
> CHECK TIRE PRESSURE
*
Check and correct the tire inflation
pressure to specifications at the earli-
est opportunity (next stop for fuel).
Refer to page
94 .
> TIRE CHECK INACTIVE
*
A temporary interference of the RDC
or a system fault. Refer to page
95
> BRAKE LAMP CIRCUIT
A bulb has failed or the circuit has a
malfunction. Refer to pages
163 , 176
or consult an authorized BMW center.
> CHECK LOWBEAMS
CHECK SIDE LAMPS
CHECK REAR LAMPS
CHECK FRONT FOGLAMPS
CHECK LICPLATE LAMP
CHECK TRAILER LIGHTS
CHECK HIGHBEAMS
CHECK BACKUP LAMPS
Defective bulb or circuit. Refer to
pages
163 , 176 or consult an autho-
rized BMW center.
> TRANS. FAILSAFE PROG
Please consult the nearest authorized
BMW center. Refer to pages
64 , 67 .
> CHECK BRAKE LININGS
Have the brake pads inspected by
your BMW center. Refer to page 126.
> REMOTE KEY BATTERY
Change the battery. Refer to
page
168 .
> CHECK COOLANT LEVEL
The coolant is too low. Top up at the
next opportunity. Refer to page
146 .
>
ENGINE FAILSAFE PROG
Fault in the Electronic Engine Power
Control EML. When braking, higher
brake application pressure may be
necessary and brake pedal travel may
be significantly longer.
Please have the system inspected by
your authorized BMW center.
All manuals and user guides at all-guides.com