16
Restarting and troubleshooting
The BMW i Charging Station restarts automatically after a power failure. The Stop/Start button LED will then illuminate in solid blue, indicating that the BMW i
Charging Station is again ready for normal operation.
If a vehicle is charging during a power loss, charging will restart automatically two minutes after power returns. During this two-minute delay, the Stop/Start
button LED will flash magenta.
Detected condition reporting
The solid red LED indicates a detected condition. Press and hold the Stop/Start button for five seconds for condition reporting as described.
LED Status
Origin
Recommendation
Flashes red and yel-
low
BMW i Charging Station
Turn power feeding the charging station OFF and then back ON. If condition conti-
nues, have the charging station serviced by qualified personnel.
Flashes red and
green
Vehicle
Have the vehicle checked by a BMW i Center.
Flashes blue and
green
Vehicle / BMW i Charging Station communi-
cations
Turn power feeding the charging station OFF and then back ON. If condition conti-
nues, have the charging station serviced by qualified personnel.
- Have the charging station pilot signal tested.
- Have the vehicle checked by a BMW i Center.
Flashes red and blue Wiring/cable/vehicle
Turn power feeding the charging station OFF and then back ON. If condition conti-
nues, have the charging station serviced by qualified personnel.
- Check supply circuit ground.
- Inspect cable for damage.
- Have the vehicle checked by a BMW i Center.
Detected condition memory
A memory feature allows the last detected condition type to be displayed.
1 With the connector disengaged from the vehicle, the key locking system unlocked, and blue LED illuminated (no detected condition registered), press and
hold the Stop/Start button for five seconds.
2 The detected condition memory will report as shown under condition reporting (see above).
3 If there are no detected conditions in the memory, the green LED flashes.
4 After one minute, the display will return to normal mode (solid blue LED).
NOTE:
If the vehicle is plugged in (connected) for charging during the one-minute display of the detected condition memory, the display will return to normal
and charging will start without delay.
NOTE:
When the BMW i Charging Station is disconnected from the power supply system, the detected condition memory is cleared.
Содержание 61 90 2 346 992
