BMB take control ur81slr, Руководство пользователя

Страница: 16 / 60

P/N 033000=13891 16 Rev.15-05-06
Changing the X10 House Code
The Take Control Remote is set to House Code A by default.
In most cases you do not need to change this setting, unless
another X10 system in your area causes interference.
1. Press the SETUP button until one of the Mode LED’s
stays lit. Release the SETUP button.
2. Press the numerical key(s) for the House Code selected
(1=A, 2=B, ...... 16=P).
3. Press the -/-- (12) button to confirm the House Code. The
LED will extinguish.
Note:
The House Code selected must be the same as the
House Code used by your Transceiver Module.
Home Control
If you want to control your lights and appliances you will also
need, besides the Take Control Remote, a X10 compatible
Home Automation Transceiver Module. This can be plugged
into any electrical socket. Use a Transceiver Module
(available separately) and connect your table lamp or other
electrical appliance. Switch on/off: control everything with
the Take Control. The Transceiver Module converts the RF
signals of the Take Control into an X10 signal that is
transferred via the mains power line. All other X10 modules
that are connected to your mains, are also operate able
through the Take Control Remote.
Contact your retailer for additional information.
5. Troubleshooting
The remote doesn’t work or loses codes entered
• Confirm with your original remote that the equipment works
correctly.
• Make sure that you have pressed the corresponding mode
key of the equipment or device that you want to control.
• If the listed code does not work, try the AUTOSEARCH
method or enter the next code of that brand.
• Check that the batteries have the correct polarity position.
• The programming of the remote requires 2 AAA Alkaline
batteries (new). If the remote looses codes within a few
days/weeks the problem can be solved by using 2 new
batteries.
• If the LED is lit permanently, in general it will be necessary
to replace the batteries.
• Set the remote back to factory default.
How to set the Take Control Remote back to factory
default (Master reset)
• Press and hold SETUP (8) until the LED indicator (2) lights
steadily. Release SETUP .
• Press and release the STOP key (20) twice.
• Press and release the

MUTE key (4).
• The LED (2) turns off after few seconds.