635 W. Michigan Street Orlando, FL 32805 · PH 407-426-7674 · Fax 407-426-7721
Page 4 of 8
Pocket Clips
Section 3- Mounting the Reservoir and Water Disperser
1.
Locate the reservoir (L) and hang it on the reservoir wall bracket (D) cleats. Make certain the reservoir (L) is
well seated and centered on the bracket.
2.
Place the pump assembly (H) inside the reservoir (L) close to the right edge.
DO NOT plug the pump (H) into
an outlet. Operating the pump dry will void any warranty and burn out the pump.
3.
The water disperser (E) will sit in the pocket clips on the stone wall bracket (B). Until the stone is mounted it
will need to be placed temporarily above the bracket so the stone can be mounted. Using your keyhole
template (A) gently ease it between the stone wall bracket (B) and the wall ¼” so that it is firmly held in place.
Next slide the two tabs on the disperser (E) behind the bracket template (A) so it is holding up the disperser
(E). Do not push the disperser (E) all the way down; just enough so that is doesn’t fall.
4.
Place the vinyl tubing inside the tube clip. It should be loose so the tube can slide freely up and down when
the disperser is moved.
5.
Make certain the vinyl tubing and plumbing hang straight down into the reservoir.
Section
4 – Mounting the Stone
1.
Remove the stone from the box. Due the weight you will need 1 or 2 people to assist with the installation.
Your stone ships face down. Notice the bracket that has been anchored to the back of the slate. This will
hook onto the cleat of the stone wall bracket (B). The cut angle is the top of the stone. Using two strong
people lift the slate up from the pallet and carefully move the stone to the installation area. Position the
stone so it is centered in front of the reservoir (L). You may wish to rest the stone on scrap wood so you can
grip under the stone when lifting to mount it on the bracket.
