19
contact
|
CUSTOM PRO MATRIX
USER MANUAL
The Blustream Custom Pro matrix products include multiple options for control and routing of IR when using the IR
control boards. IR matricing can be achieved (routed IR from zone to any matrix output, or matrix input to any receiver
output), using TCP/IP or serial commands to select the route an IR signal can be sent from / to.
The Blustream PRO-8IR-V2 control board, and the CUSTOMPRO-HUB16 are supplied with all necessary IR hardware
required (see Package Contents towards rear of this manual), and includes:
Infrared (IR) Distribution
IR Emitter - IRE1
Blustream 5V IR emitter designed for discrete IR control of
hardware.
IR Receiver - IRR
Blustream 5V IR receiver to receive IR signal and distribute
through Blustream products.
IR Control Cable - IRCAB
Blustream IR control cable 3.5mm stereo to 3.5mm mono
for linking 12V third party control solutions to Blustream 5V
products via IR.
Please Note:
cable is directional as indicated.
Infrared 3.5mm Pin-Out
IR Emitter - Mono 3.5mm
IR Receiver - Stereo 3.5mm
Signal
5V
Ground
Signal
Ground
Please Note:
Blustream IR hardware do not include flashing
diodes to indicate IR signals being emitted or received.
Relevant IR cabling is suppied with the 16x16 chassis, please
see package contents towards the rear of this manual.
When purchasing the PRO-8IR-V2 with the 8x8 chassis, the
following IR cables are provided:
• 9 x IR emitter (IRE1)
• 9 x IR receiver (IRR)
• 9 x IR 3.5mm - 3.5mm stereo to mono,
12V to 5V control
cable (IRCAB)
