blupura PANTAREI, Руководство по эксплуатации и обслуживанию, Страница: 15 / 28

15
Installation
Unpacking
Remove the two plastic tape. Remove the
cardboard box and the internal protective
packaging by sliding them up and over
the top.
Once you have unpacked the unit, ensure
that it is not damaged. You must inform
the reseller about any damages as soon
as possible after delivery.
If the unit has been shipped horizontally
or at an angle, it will be necessary to wait
at least 8 hours before setting it up, in
order to allow the cooling circuit to reset
itself.
Ensure that the unit is installed and
connected to the main supply by a
qualified technician in compliance with
the manufacturer’s instructions and the
local safety guidelines.
The end user is not permitted to access
the internal service parts of the unit. Only
technical personnel should carry out
operations of this nature.
Siting the unit
Wear safety gloves when handling the
unit. Take care when touching the metal
parts, which could be sharp.
Site the unit away from sources of heat.
Leave at least 4 inch around the unit to
allow for aeration.
Mount the swan neck tap (2) putting it into
the bayonet. Insert the tap (2) by screwing
it clockwise into its housing and secure it
with the screw located on the base (3).
Fig. 15.2
Fig. 15.1
1
2