GETTING STARTED
1.
Once the printer is switched ON, RED LED will blink a few times while
configuring Bluetooth Baud Rate & default parameters of the Printer.
Please wait for this process to be completed before using the Device.
2.
If the Printer is not getting switched ON:
a.
Check if the Power adapter is properly inserted.
b.
Check if the adapter is properly plugged into the mains and its
Red LED is glowing
c.
Press FEED Button continuously while turning ON the Power
Switch for 3-5 Sec to get test print
3.
Test Print shows following important information:
a.
Bluetooth Name
(e.g.BTprinter1234), which will show on your
Bluetooth Phone / tab / laptop.
b.
Firmware version
c.
Communication:
shows Bluetooth/USB if both modes are
working. It will not show the mode(s) that is/are not working.
4.
Bluetooth Passwords for pairing (if required): 1234 or 0000
5.
Use proper USB Shielded data cables for proper printing using USB.
6.
If the cutter gets stuck
, turn off the power and restart the Printer. If
the cutter is still stuck, then remove this front cover by pulling from
both the sides and bring the cutter back in place manually, by rotating
the gear.
