System will not turn on:
Check power plug and breakers.
Low water level alarm:
Add more water – the water level can be dropped during operation by the pump due to water
turbulence.
Low water level alarm turns on after a few seconds of operation:
Add more water – The pump generates “waves” – sometimes these waves will cause the
water level at the sensors to fluctuate up and down. The waves sometimes drop the water
level right under the sensor and will cause a low water alarm. This is normal and you just
need to add more water.
Temperature read does not match thermometer:
Sous Vide circulators are calibrated to a scientific platinum primary standard which is far
more accurate than store thermometers.
Lights in house are slightly flickering when system is on:
This is normal as the circulator is modulating power.
Error code EE1 will be appeared in below situation with alarm sound:
1. No water in tank
2. Water below minimum level
3. Appliance in situation of short circuit
TECHNICAL SPECIFICATIONS
Power rate:
220~240V, 50HZ, 1000W
Temperature range:
0°C 90 °C
(suggest keeping cooking time no more than 48hours for a specified recipe)
Temperature Stability : ± 0.5ºC
Circulation pump:
10 LPM
Do not dispose of the device in normal domestic waste
Dispose of the device over a registered waste disposal firm or through your communal was-
te disposal facility. Observe the currently valid regulations. In case of doubt, consult your
waste disposal facility.
8
EN
2021-06-14 OCG BluMill Sous Vide Manual V03.indd 8
2021-06-14 OCG BluMill Sous Vide Manual V03.indd 8
07-07-2021 09:03
07-07-2021 09:03
