TANDEM plus BLUMOTION
Subject to technical modifications without notice. © 2015 Blum Inc.
Dimensions in millimeters
(inch equivalents as noted)
2
Preparing for hardware installation
NOTE:
Use of the T65.1600.01 TANDEM template is essential for accurate location and angle of
pre-bored locking device holes and accurate boring for rear hook holes
Drawer specifications
6
mm bit with
stop collar
2.5
mm bit with
extension chuck
Pre-boring holes for
locking devices
Pre-boring holes
for rear hooks
75°
Installation screw
606N or 606P
TANDEM template
T65.1600.01
T51.1801
T51.1901
Locking device
with side-to-side adjustment or
without side-to-side adjustment
Drawer insertion
Extend the concealed runners fully. Place the drawer on the runners and close.
The locking devices automatically engage with the runners. Make adjustments if necessary.
Drawer removal
1
Squeeze orange handles on locking devices
2
Pull drawer straight out and up
1
2
Drawer box specifications
Front view
NOTE:
Drawer side material thickness may vary. Accurate measurement of drawer side
material thickness should be used when calculating outside drawer width using the table
below. Inside drawer width
must
equal opening width minus
42
(1-21/32") for TANDEM
to align and function optimally.
Calculating outside drawer width
For drawer side thickness
16
(5/8")
15
(19/32")
14
(9/16")
13
(1/2")
12
(15/32")
Deduct from opening width
10
(13/32")
12
(15/32")
14
(9/16")
16
(5/8")
18
(23/32")
Example:
For 21" opening width and a 5/8" thick drawer, 21" minus 13/32" = 20-19/32" drawer width
drawer side thickness
maximum
16
(5/8")
13
(1/2")
bottom recess
14
(9/16")
bottom clearance
37
(1-1
5/32")
maximum
drawer height =
opening minus
20
(25/32")
opening width
opening height
opening width minus
42
21
(13/16")
outside drawer width
6
(1/4")
minimum top
clearance
606N or 606P
Screws
662.1150.HG
or
