Recharging
Recharging GET is done via a Micro USB cable that comes with
the package. Connect the cable to the USB port located on
GET’s bottom edge and to a suitable power source. Normal
charging time is approximately one hour.
GET’s LED will show a red light while being recharged and a
green light when fully charged.
If the battery power falls below 10 percent, the LED will flash
red every 4 seconds.
Resetting
If you experience a malfunction or freeze and cannot power off
GET, you can reset the device by inserting a paper clip or ball pen
point in the reset hole located to the lower right side of the Micro-
USB connector.
