Z 1 T / S C O R E D R I L L S T A N D
9
Ø
After placing the machine in work area, connect a safety chain or strap if necessary.
o
A safety chain should attach to the machine (preferably through the carrying handle or O bolt) as
well as attached to the work area in such a manner that prevents the machine from detaching or
falling from the work area.
Ø
If necessary, adjust drilling angle.
o
NOTE: If adjusting from the 90 degree position you will need to take out the hex bolt on the front
of the machine under the drill spindle that tightens into the drill base.
o
Loosen the lower side bottom bolt on the base if necessary, the side black handle and back
adjusting hex bolt.
o
Adjust the angle and tighten the rear hex bolt. Tighten the side handle bolt. Tighten side bottom
bolt in the base.
§
NOTE: If adjusting back to a 90 degree angle, also tighten the front hex bolt below the
spindle that tightens the stand into the base.
Ø
Ensure the feed handles are securely attached to the feed spindle.
