BlueMarine Reef 200, Инструкция по эксплуатации

Страница: 20 / 56

20
Manual ReefPower 3500 Pump
INSTALLATION
• Rinse the pump and all the parts with clean tap water before installation.
• Remove the filter cover of the pump, it is not necessary in a marine aquarium.
• Install the pump, connect the hose on to the pump.
• Turn the pump on by plugging it into the socket, make a drip loop in the cable.
MAINTENANCE
• Scaling is an issue in a marine aquarium and may affect the operation of the pump.
• Monthly cleaning is necessary in order to ensure proper operation.
• Always remove the plug from the socket before any maintenance on the pump and tank.
• Open the pump and remove the rotor and ceramic shaft.
• Clean the rotor and shaft in a solution of 50% vinegar and 50% water, let it soak at least 15 minutes.
Check if the rotor rotates freely on the shaft. In some cases, it may require to soak longer to remove all the lime
scale.
• Mount the pump and place it back into the aquarium sump.
• The rotor is subjected to wear. Depending on usage it should be replaced every year, this is normal wear and is not
covered by warranty. Replacement rotors are available from your dealer.
TECHNICAL DATA
• Power 45 W
• Flow rate 3240 L/h
• Jet 2.4 m
• Inlet 25 mm
• Outlet 25 mm
• Power supply 230-240V/50Hz