2
3
GB
6. prise d’alimentation
7. câble d’alimentation
8. ballast
9. contrôleur
10. Vis de fixation sur l’aquarium
(Vis nylon 4 x15 mm)
6. Stekker
7. Stroomkabel
8. Trafo
9. Controller
10. Schroeven tbv bevestiging
aan het aquarium.
(4 x nylon schroeven)
Safety:
1. Read manual carefully before usage.
2. Only suitable for indoor use. Intended for Aquarium usage, not intended for household room illumination.
3. Ensure voltage shown on the label matches to the mains supply voltage.
4. Never look directly at the LEDS! UV and Invisible Radiation (IR) emitted from this light may cause permanent eye and/or skin damage,
always minimize exposure to eyes and skin. The supplier is never responsible for any wrong usage of this light.
5. Although the LED lamp is splash waterproof it should not be submerged in water and there should be at least 15mm between water level and lamp.
6. Only plug light into mains after the LED lamp is firmly mounted above the aquarium.
7. Always dry your hands before doing any jobs on the LED lamp or operating the lamp switch.
8. Always disconnect electrical supply before you perform any maintenance on aquarium and LED light.
9. The LED unit can get warm, allow adequate time to cool down before attempting any maintenance.
10. Make sure cable and light are undamaged before usage, If damaged the supply cord cannot be replaced, the whole unit needs to be recycled.
11. If overpowered the ballast can be replaced, buy a replacement ballast at your dealer.
12. In the unlucky event that the LED unit falls into the water, first unplug it and then retrieve it by using the cable to lift the unit out of the water.
13. Warranty is not valid when unit is damaged due to submersing.
14. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible
for their safety. Special care should be taken with the use of electrical equipment by or near children.
Installation;
Required tools, small flathead Screwdriver included.
Step 1:
Attach the flexible bracket to the bracket support, using the 4 short bracket bolts and tighten these down with the screwdriver.
Step 2:
Attach flexible bracket to LED unit by pushing the legs into the unit.
Step 3:
Place bracket support on the aquarium tank, adjust legs, with supplied screws of different length, depending on the glass thickness
choose the correct screw and tighten the bracket onto the glass tank.
Step 4:
Connect remote control to power cable, tighten the connection to make it waterproof, connect ballast and powerplug.
Step 5:
Optional hanging bracket installation, a hanging bracket is available as an accessory at your Blue Marine dealer.
Index display screen:
1.
Daytime mode
2. Sunrise or Sunset mode
3. Dawn or Night time mode
4.
Light Off mode
5.
(In current time mode this shows hours and minutes)
1
2
4
5
3