55
We reserve the right to make changes without any prior notice.
Translation from original instructions
7.2.3.4
Three-monthly cleaning of the coils
Three-monthly cleaning is essential to prolong the life of an e-coated coil and is necessary to remain covered by the war-
ranty.
Failure to clean will void the warranty and can cause reduced efficiency and life in the envisaged environmental conditions.
For routine three-monthly cleaning, if there is a film of grease or oil, it must first be removed from the coil with the detergent
for coils approved below (see list of approved products)
After cleaning the coils with the approved detergent, apply the approved product for removing any chlorides present.
The following detergent, provided it is used in compliance with the manufacturer's instructions for correct mixing and
cleaning, has been approved for use on e-coated coils for removing mould, dust, soot, grease residues, fibres and other
particules.
Product
Dealer
Product code
Enviro-Coil Concentrate
HYDRO-BALANCE CORPORATION
H-EC01
TELEPHONE: 800 527-5166 FAX: 972
394-6755
P.O. Box 730 Prosper, Texas 75078
Enviro-Coil Concentrate
Home Depot Supply
H-EC01
The following product is recommended for removing chlorides.
Product
Dealer
CHLOR*RID DTS™
CHLOR*RID International, Inc PO
Box 908 Chandler, Arizona 85244
Bus:(800) 422-3217
Bus Fax: (480) 821-0364
This product is not intended for use as a degreaser.
Procedure for removing soluble chloride salts:
- Removal of surface dirt - To ensure effective cleaning, the product must be able to come into contact with the salts.
These salts may be under a surface layer of dirt, grease or deposits; therefore these barriers must be removed before
applying the product.
- Apply CHLOR * DTS RID - Apply CHLOR * RID DTS directly on the coil. The product must be applied evenly so as to
wet the entire surface of the coil completely and leave no area uncovered. This can be done using a pump sprayer or
a normal spray gun. Now all that needs to be done is to rinse to eliminate the salts that have become soluble in the
product.
- Rinsing - Follow the instructions given above for periodic cleaning with water as regards the maximum temperature and
pressure of use.
Use good quality drinking water. Check with CHLOR * RID International, Inc. for recommendations on lower
quality rinsing water.
Aggressive and corrosive chemical products, bleach or acid detergents must not be used to clean e-coated
coils.
These detergents can be very difficult to rinse off the coil and can therefore accelerate corrosion and eat into
the protective surface coating.
