Page 13
Flow Verification Sensor is designed to give you two installation options.
Sensor can be installed:
!
Directly onto pumphead of Chem-Pro® pump, discharge side.
!
Anywhere on discharge side of Chem-Pro® pump.
Wiring for sensor can be connected directly to a Chem-Pro® pump. Pump will stop pumping if sensor detects no
flow. A relay will then close allowing for remote alarm indication or initiation of a back-up pump.
Install FVS Flow
Sensor -
Flow Verification Sensor should be installed on inlet (suction) side of pump tube.
When installing directly onto pump 3/8” tube discharge fitting:
Sensor includes a PVC tubing insert, located inside sensors female thread connection, that is designed to
seal sensor onto pump tube adapter. Thread sensor onto pump tube until tubing insert is snug against pump
tube fitting - do not over-tighten.
7.1
Set FVS (flow verification system) - Continued
Sensor Model Number
Actual Working Range with
Chem-Pro® Pump
ML/Min
ML/Min
30-200
FV-100
30-300
Published Flow Range
50-900
FV-200
100-1000
100-1800
FV-300
200-2000
300-3000
FV-400
300-3000
500-5000
FV-500
500-5000
700-7000
FV-600
700-7000
Confirm FVS flow range -
Flow Verification Sensor (FVS) will only function within its operating range. See chart
for available ranges.
NOTE: If pump output is less than 30 ml/min, sensor will not detect chemical and a signal will not be sent to
pump, resulting in an alarm condition.
NOTE: For low viscosity (water-like) fluids only. Consult factory if attempting to use with viscous fluids.
C3V | Diaphragm Metering Pump
Made in the USA
MODE
PRIME
Program
Minimum
Maximum
Blue-White Ind.
IP66
NEMA 4X
FVS
Sensor
®
CHEM-PRO C2F/C3F
